Thread Drawing - Wading Bird

Today I just couldn't bring myself to toss a remnant of painter's drop cloth so I thought It might be a good pallet on which to practice some improvisational, free motion thread drawing.  Since the remnant was long and narrow, whatever I drew seemed to beg to be elongated.  What better than a long legged wading bird?  This is what emerged.

Here are a few close-ups to show the stitching.

Even though I used two layers of stabilizer under the canvas, the dense, free motion thread drawing tended to make fabric outside of the edges of the bird image become somewhat "rumpled".  To salvage the thread drawing, I cut around it and then zigzag stitched it onto another canvas remnant.  That did the trick.  Because canvas tends to fray terribly, I applied a thin layer of Weldbond glue around the edges and spread it thinly with a soft bristle paint brush.  The glue dries clear and is no problem to stitch through. 

And, once again, here is the finished bird.  I used a silver Sharpie pen to color in the bill.  When completed, I hemmed both the top and bottom edges and left the ends open so that those spaces would accept a small dowel rod.  In my stash of laces and pipings, etc., I found a length of braided cotton cording that seemed to work perfectly for hanging.

Always remember, never fear to experiment.  

Sometimes wonderful things happen.

© Linda Friedman 2017.  All rights reserved

"Speaking Out" in "Threads of Resistance"

I'm totally thrilled today that my work, "Speaking Out" has been accepted into the "Threads of Resistance" exhibit that will travel the nation from July 15, 2017 through October 2018. it is "a juried exhibit of fiber Artists Circle Alliance...to protest the Trump Administrations actions and policies." Approximately 500 works were submitted in the Call for Entry so for my work to make the cut of 63 chose works, I am very honored.

The Artists Circle Alliance has posted photos of ALL the art works that were submitted. To view them, go to http://threadsofresistance.org/the_artwork.html

"Speaking Out" (36" Wide x 24" Long)

Always remember, never fear to experiment.  

Sometimes wonderful things happen.

© Linda Friedman 2017.  All rights reserved

How to Make Stamps with Latex Caulk

It seems that I never stop looking for new ways to create my own stamps for printing on fabric.  What follows is how I created stamps using latex caulking.  Here are a few that I made yesterday.

And here is how I made them.

I started with wood blocks that I cut from stock lumber.

 Then I pulled out a caulking gun and some caulking that was in the garage.

 I squeezed caulking material onto the blocks and spread it smoothly over the blocks with one of those mock-up credit cards that litter our mail almost weekly.  Once I had a smooth surface of caulking, I used a letter opener to scribe a pattern into the caulking material.

Once again, here is what the blocks looked like after I had scribed designs into them.  The edges of the scribed lines tended to pull up but I set the blocks aside to dry anyway.

Although the directions on the caulking material indicate that the product is paintable within 30 minutes, I let the blocks dry for a couple of hour just to make sure they were good and dry. 

I knew that the surface needed to be flat in order to achieve good prints from the blocks, so I laid parchment paper over them and rolled the surfaces flat with a brayer.

I had a swath of canvas lying around and decided to try out the stamps using Setacolor fabric paint.  Here are a couple of closeups of the result.

I like the somewhat uneven nature of each print that resulted from the slightly uneven surface of each stamp.  Unlike store bought stamps that always produce the same printed image, these stamps take on a character all their own with each and every printing.

Here is the entire long, narrow swath of canvas printed.

Always remember, never fear to experiment.  

Sometimes wonderful things happen.

© Linda Friedman 2017.  All rights reserved