Pages

Tuesday, December 1, 2015

Block Printing with Craft Foam #2

This post is a continuation from yesterday's post.  Here I have made multiple printings from the three blocks cut from sticky backed craft foam.  To see the process for cutting the blocks click HERE.

These are the tools used in printing the blocks.
 
In the past I have used a brayer to apply the paint, but recently I have been using a foam roller from a home improvement store with good results.  The tray onto which I poured the paint is a hard plastic one that I salvaged from a food product package.  The paint is contained within its raised edges and it rinses off very easily.  

I marked off a grid pattern with soft pencil lines on a large swath of white fabric. Then I printed multiples of the circles block with Cardinal Red Setacolor fabric paint.
Next I printed the broad striped block over the circle block with Black Lake Setacolor fabric paint.
When that printing was dry, I printed over the circle and broad striped blocks with the narrower, diagonal strip block with Light Green Setacolor fabric paint.
I then cut rows of blocks apart, lined up the prints and sewed the rows together.  Because I am creating a work to address the challenge theme of "Crossings", I cut a 3/4" wide and long stencil  from card stock and stenciled the horizontal lines with  the same Lake Black Setacolor fabric paint that I had used  for the broad striped block prints.

Tomorrow I will post about auditioning colors to use in over-painting.  These posts are the beginnings of my participation in the 31 Day Blog Writing Challenge.  If you, too, would like to participate, link to http://muppin.com/…/inde…/the-31-day-blog-writing-challenge/


Until tomorrow...
Always remember, never fear to experiment.  
Sometimes wonderful things happen.
© Linda Friedman 2015.  All rights reserved

6 comments: